Gravity water flow sensor (1/2″) for Arduino measures the rate of a liquid flowing through it. The YF-S201 water flow sensor consists of a plastic valve body, flow rotor and hall effect sensor. It is usually used at the inlet end to detect the amount of flow. When liquid flows through the sensor, a magnetic rotor will rotate and the rate of rotation will vary with the rate of flow. The hall effect sensor will then output a pulse width signal. Connect it to a microcontroller and you can monitor multiple devices such as your coffee maker, sprinkler or anything else, and control the water flow rate as per needs.

• 11mm inner diameter, 20mm outside diameter
• Proof water pressure of <1.75 MPa
• Water flow range of 1-30L/min, voltage range from 3.5 to 12 V
• Operating current of 15mA (DC 5V)
• Insulation resistance of >100Mohm, accuracy is 5% (2~30L/min)
• Output pulse duty ratio of 50% 10%
• Working humidity range from 25% to 95% RH (no frost)
• Dimension is 62mm x 36mm x 35mm/2.44 x 1.37 x1.37inch, weight is 52g

Other details

Brand DFROBOT Part Number SEN0217 Quantity Each Technical Data Sheet EN Manufacturer Product Page EN

All product and company names are trademarks or registered trademarks of their respective holders. Use of them does not imply any affiliation with or endorsement by them. Image is for illustrative purposes only. Please refer to product description.